Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 IPv6 Basics Configuration Commands
1-6
Examples
# Display the IPv6 information of VLAN-interface 2.
<Sysname> display ipv6 interface vlan-interface 2
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::1234:56FF:FE65:4322
Global unicast address(es):
2001::1, subnet is 2001::/64
Joined group address(es):
FF02::1:FF00:1
FF02::1:FF65:4322
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
Table 1-5
Description on fields of the
display ipv6 interface
command
Field
Description
Vlan-interface2 current state
Physical state of the interface
Line protocol current state
Link layer protocol state of the interface
IPv6 is enabled
IPv6 packet forwarding state of the
interface (IPv6 packet forwarding is
enabled in the example)
link-local address
Link-local address configured for the
interface
Global unicast address(es)
Aggregatable global unicast address(es)
configured for the interface
Joined group address(es)
Address(es) of multicast group(s) that the
interface joins
MTU
Maximum transmission unit of the interface
ND DAD is enabled, number of DAD
attempts
Number of DAD attempts, with DAD
enabled
ND reachable time
Neighbor reachable time
ND retransmit interval
Interval for retransmitting a neighbor
solicitation (NS) message
