Installation Manual
H3C SecPath F1000-A Firewall
Chapter 4 Booting and Configuration
4-2
Figure 4-2
Set up a new connection
Step 2: Set the terminal parameters.
Set the HyperTerminal parameters of Windows98 as follows:
1) Select serial interface
Select the serial interface to be used from the Connect using drop-down list as shown in
Figure 4-3. The serial interface selected here must be the one connected to the console
cable.
Figure 4-3
Select serial interface
2) Set the serial interface
The [Port Settings] tab appears as shown in Figure 4-4, and set the serial interface
parameters as follows:
