Installation Manual
H3C SecPath F1000-A Firewall
Chapter 5 Software Maintenance
5-7
5.1.4 Upgrading an Application Program Using TFTP
Upgrade an application program with net is to download the application program using
an Ethernet interface. In this approach, the firewall is the client that needs to be
connected to the TFTP server using one of its fixed Ethernet interfaces.
Caution:
The H3C SecPath Series Firewall does not provide TFTP server programs. You should
purchase and install one by yourself.
The H3C SecPath F1000-A can only act as the TFTP client, so you can only upgrade
an application program using TFTP, shown as follows:
z
Start the TFTP server
z
Start the TFTP server on the PC connected to the Ethernet interface on the
SecPath 1000F and set the path to the file to be downloaded.
z
Configure the SecPath 1000F
Step 1: Start the firewall and enter the Boot menu (see section 5.1.1 “Boot Menu”).
Select
2
to enter the Net Port Download Menu. The system displays the following
message:
Net Port Download Menu:
1: Change Net Parameter
2: Download From Net
3: Exit to Main Menu
Enter your choice(1-3): 1
Step 2: Select
1
to configure the network interface parameters (including the interface
in use and the IP address and subnet mask of the interface) and the TFTP server
parameters (including the IP address of the Ethernet interface on the TFTP server and
the file name of the application program).
Change Download parameter
Download device ETH0
Download file(Max 60 char) :system
IP address of ETH0 :192.168.1.15
Subnet mask for ETH0 :255.255.255.0
IP address of the server :192.168.1.10
IP address of the gateway :10.110.95.117
