Installation Manual
H3C SecPath F1000-A Firewall
Chapter 5 Software Maintenance
5-11
[VPNGateway-luser-vpngateway] service-type ftp ftp-directory flash:
Step 5: Add an authority level.
[VPNGateway-luser-vpngateway] level 3
Step 6: Enable the FTP server.
[VPNGateway] ftp-server enable
After the FTP server is enabled and the user is added onto the firewall, any FTP client
program can use the username and password to log onto the FTP server.
III. Uploading/Downloading an application program/configuration file and
uploading the Boot ROM program
Step 1: In the DOS environment, access the directory containing the application
program/Boot ROM/configuration file. Execute the
ftp
command to set up an FTP
connection with the firewall, for example:
C:\version\ftp 10.110.10.10
If the connection is set up, the following message appears (taking Windows98 for
example):
Connected to 10.110.10.10
220 FTP server ready on VPNGateway at
User(10.110.10.10:(none)):
Step 2: Log onto the FTP server using the username and password set on the SecPath
1000F.
User(10.110.10.10:(none)):
VPNGateway
331 Password required for ftp
Password:
230 User ftp logged in
ftp>
Appearance of the prompt “ftp>” indicates that you can begin uploading/downloading
the desired file.
Step 3: Upload/Download the application program/configuration file/Boot ROM.
Note:
On the firewall, the default name of the application program is "system”, the
configuration file “config.cfg”, the extended segment of the Boot ROM “bootrom”, and
the entire Boot ROM “bootromfull”.
z
Upload the application program/Boot ROM/configuration file
ftp> put
