Installation Manual
H3C SecPath F1000-A Firewall
Chapter 8 Multifunctional Interface Modules
8-16
Figure 8-21
SSL module
8.7.3 Module Attributes
Table 8-9 shows the attributes of the SSL module.
Table 8-9
SSL module attributes
Attribute
Description
Supported protocol
SSL
Hardware algorithm
Key algorithm (DES, 3DES, AES and RC4)
Authentication algorithm (HMAC-MD5 and
HMAC-SHA-1)
8.7.4 Panel and Module LEDs
Figure 8-22 shows the panel of the SSL module.
Figure 8-22
SSL module panel
Table 8-10
LEDs on the SSL module
LED
Description
STATUS
OFF means the module is not powered, or the power supply is OFF
or in fault; ON means an Rx link is present.
ACTIVE
OFF means the module is normal but no packets are being
transmitted/received on the interface; blinking continuously means
the module is normal and packets are being transmitted/received on
the interface; blinking for two seconds and then OFF means the
module initiation is completed.