Manual version: 6PW101-20170411
BOM: 3123A19Y
iv
LED Status
Description
System LED (RUN)
Off
No power input or the firewall card is faulty.
Steady green
The system is not operating correctly.
Flashing green (1 Hz)
The system has started up and is operating correctly.
Flashing green (8 Hz)
The system is loading the software.
Combo interface LED
(LINK/ACT)
Off
No link is present on the port.
Steady green
A link is present on the port.
Flashing green
The port is sending or receiving data.
5
Installing and removing the card
CAUTION:
•
Wear a reliably-grounded ESD wrist strap before you install or remove the firewall card.
•
Do not touch the components on the PCB.
The slots on the H3C S10500 switches are either horizontally oriented or vertically oriented. When
installing the card in a horizontal slot, make sure its PCB faces up. When installing the card in a vertical
slot, make sure its PCB faces left.
This section uses a vertically oriented card to describe the installation and removal procedures.
5.1
Installing the card
1.
Remove the blank panel from the slot for the card at the front of the switch.
This manual uses slot 9 as an example.
2.
Place the card vertically with the surface-mounted components facing left. Pull outward the ejector
levers and gently push the card in along the slot guide rails until the card is in close contact with
the backplane.
3.
Push the ejector levers inward.
4.
Tighten the captive screws with a Phillips screwdriver to secure the card in the slot.
