109
Hardware Command
compatibility
MSR 20
No
MSR 30
Yes
MSR 50
Yes
MSR 2600
Yes
MSR3600-51F Yes
To change the aggregation mode of an aggregation group that contains member ports, remove all
the member ports from the aggregation group first.
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to operate in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation port-priority
Use
link-aggregation
port-priority
to set the aggregation priority of a port.
Use
undo
link-aggregation
port-priority
to restore the default setting.
Syntax
link-aggregation
port-priority
port-priority
undo
link-aggregation
port-priority
Default
The aggregation priority of a port is 32768.
Views
Ethernet interface view
Default command level
2: System level
Parameters
port-priority
: Specifies a port aggregation priority in the range of 0 to 65535. The smaller the value,
the higher the port aggregation priority.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware Command
compatibility
MSR800 Yes
MSR 900
No
MSR900-E Yes
MSR 930
Yes
MSR 20-1X
No
