125
Default
GVRP is disabled.
Views
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default command level
2: System level
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware Command
compatibility
MSR800 No
MSR 900
No
MSR900-E No
MSR 930
No
MSR 20-1X
No
MSR 20
No
MSR 30
Yes
MSR 50
Yes
MSR 2600
Yes
MSR3600-51F Yes
Settings in system view take effect globally. Settings in Ethernet view or Layer 2 aggregate interface
take effect on the current interface. Settings in port group view take effect on all ports in the port
group.
To enable GVRP on a port, enable GVRP globally before you enable it on the port.
In interface view, you can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
Examples
# Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.
Related commands
display gvrp status
gvrp registration
Use
gvrp
registration
to configure the GVRP registration mode.
Use
undo gvrp
registration
to restore the default.
Syntax
gvrp
registration
{
fixed
|
forbidden
|
normal
}
undo gvrp
registration
