6
5
Installing a SATA drive in the drive (hard disk) slot
SATA
You can remove the drive from the drive slot only when the drive LED (HD) is off.
You can remove the drive when the device is operating and must wait for a minimum of 10 seconds
before re-installing it or installing a new drive.
只有在硬盘指示灯处于关闭状态才可以拔出硬盘。
硬盘带电拔出后，请至少等待
10s
，方可重新插入硬盘。
!
Connecting an Ethernet cable
Connect one end of the Ethernet cable to the target Ethernet port on the device and the other end of the
cable to the target Ethernet port on the peer device.
将以太网线缆一端连接到设备的固定以太网口，另一端连接到对端设备的以太网口。
No SATA drive is provided with the device. Purchase one as needed.
硬盘不随机提供，用户可以根据实际需要自行选购。
Four drive fastening screws are provided with the drive carrier.
硬盘紧固螺钉随机提供，随硬盘盒包装随机发货。
3
4
5
Installing an interface module
!
Only the SIC-M2-SATA riser module is hot swappable.
仅
SIC-M2-SATA
硬盘转接模块支持热插拔。
1
2
Installing the drive on the device.
安装硬盘
1
2
2
Installing a SATA drive on the drive carrier.
安装硬盘盒
1. Push the drive slowly into the drive carrier with the golden plating facing
downwards.
硬盘的金手指朝下，将硬盘水平缓慢的推进硬盘盒中。
2. Use the four fastening screws to secure the drive to the drive carrier.
用十字螺丝刀，顺时针旋紧硬盘盒左右两侧的四颗紧固螺钉。
Installing an M.2 SSD drive
M.2 SSD
!
To use an M.2 SSD drive on the router, first install it on a SIC-M2-SATA riser module.
SIC-M2-SATA
硬盘转接模块要安装
SSD
硬盘后才能正常使用。
1
2
3
