10
Figure 5 Install/remove a PSR1400-D power module
Installing a Power Module
1.
Wear an ESD-preventive wrist strap and take a new power
module out of its package. Check that the input mode of the
power module is correct.
2.
Grasp the handle of the module with one hand and hold the
module bottom with the other. Slide the module slowly along the
guide rails into the chassis until it snaps into the chassis
backplane.
NOTE:
You need to follow the forward inertia of the power module when
plugging it into the chassis. To prevent damage to the power
module and the connection terminals on the backplane, make
sure to pull the module out first in case of any misalignment, and
then push it in again.
