9
2.
Thread the flat-blade screwdriver through the hole in the handle
of the filler panel and pull the filler panel out.
Skip this step if the target slot does not have a filler panel
installed.
Figure 6 Removing a filler panel
3.
Unpack the power module.
4.
Correctly orient the power module.
If you install the power module in a left power module slot, make
sure the latch is above the handle. If you install the power
module in a right power module slot, make sure the latch is
below the handle.
5.
Holding the handle of the power module with one hand and
supporting the bottom of the power module with the other, slide
the power module along the guide rails into the slot until you
hear a click.
