8
Name
Center
wavelen
gth (nm)
Fiber
mode
Fiber
diameter
(µm)
Model
band
width
(MHz*
km)
Transmi
ssion
distance
Interface index (dBm)
Output
optical
power
Receive
sensitiv
ity
Optical
saturat
ion
H3C X130
10G SFP+
LC LRM
Transceiver
1310 MMF
50/125
1500
220 m
(721.78 ft)
–6.5 to
+0.5
≤
–6.5
≤
+1.5
1310
MMF
50/125
500
220 m
(721.78 ft)
–6.5 to
+0.5
≤
–6.5
≤
+1.5
1310
MMF
50/125
400
100 m
(328.08 ft)
–6.5 to
+0.5
≤
–6.5
≤
+1.5
1310
MMF
62.5/125
200
220 m
(721.78 ft)
–6.5 to
+0.5
≤
–6.5
≤
+1.5
1310 MMF
62.5/125
160
220 m
(721.78 ft)
–6.5 to
+0.5
≤
–6.5
≤
+1.5
H3C X130
10G SFP+
LC LR
Transceiver
1310 SMF
9/125 N/A
10 km
(6.21
miles)
–8.2 to
+0.5
≤
–14.4
≤
+0.5
H3C X130
10G SFP+
LC ER
40km
Transceiver
1550 SMF
9/125 N/A
40 km
(24.85
miles)
–4.7 to
+4
≤
–15.8
≤
–1
Connection procedure
WARNING!
Do not stare into any open apertures of operating transceiver modules or optical fiber connectors.
The laser light emitted from these apertures might hurt your eyes.
CAUTION:
Insert a dust cap into any open optical fiber connector and a dust plug into any open fiber port or
transceiver module port to protect them from contamination and ESD damage.
To connect an optical fiber:
1.
Insert an SFP/SFP+ transceiver module into an SFP/SFP+ port on the interface module.
2.
Identify the Rx and Tx ports on the SFP transceiver module. Use the optical fiber to connect the
Rx port and Tx port on the transceiver module to the Tx port and Rx port on the peer end,
respectively.
3.
Verify the LINK LED.
{
If the LED is on, a fiber link has been set up.
{
If the LED is off, no link is present. The reason might be wrong connection of the Tx and Rx
ends. Swap the fiber connectors in the Tx and Rx ports at one end of the fiber.
