29
IMPORTANT:
•
Make sure no filler panel or card is installed on the front panel of the switch before you remove or install
a lower cable management bracket.
•
Keep the removed chassis panel and cable management brackets for future use.
Installation procedure
Each S12500 switch has keyhole standoffs on its cable management bracket and keyholes on the chassis
for attaching the cable management bracket to the chassis. See
Figure 27
Keyhole standoff and keyhole
(1) Keyhole standoff
(2) Keyhole
Installing an upper expansion cable management bracket
1.
Holding the notches on both sides of the chassis panel above the upper cable management
bracket, gently remove the panel.
2.
Pressing the two sides of the front panel, pivot the power frame front panel upward.
3.
Loosen the fastening screws on the upper cable management bracket with a Phillips screwdriver.
4.
Align the keyhole standoffs on the rear of the cable management bracket with the keyholes on the
chassis and remove the cable management bracket.
5.
Align the keyhole standoffs on the upper expansion cable management bracket (with a mark) with
the keyholes on the chassis.
6.
Push the expansion cable management bracket forward until it makes close contact with the
chassis. Then pull the expansion cable management bracket downwards a little until the keyhole
standoff fits into the keyhole on the chassis.
7.
Unpack the screws come with the expansion cable management bracket and fasten them with a
Phillips screwdriver to attach the expansion cable management bracket to the chassis.
8.
Close the power frame front panel.
Summary of Contents for S12500 Series
Page 40: ...30 Figure 28 Installing an upper expansion cable management bracket 1 2 3 4 5 6 7...
Page 109: ...99 Figure 74 Replacing a card for the S12504 A Card to be removed B Card to be installed...
Page 149: ...139 Figure 85 Loopback operation on an optical transceiver...
Page 164: ...154 Figure 100 Example of a device label...
