7-5
Figure 7-6 Affixing a label
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate must be on
top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure
the label is facing out, as shown in
Figure 7-7 Affixed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a network cable. For
more information, see "
Affixing a label to a network cable
." For the example of affixed labels, see
TO :
B0 3
–
4 8 V 2
TO :
B0 3
–
4 8 V 2
TO
:
B
03
–
48
V
2
