4-3
Figure4-2 Installing an MPU (S12508G-AF switch)
Installing an MPU for the S12504G-AF
The MPU slot numbers on the chassis and the module identifiers on the S12504G-AF MPUs are pink
marked.
To install an MPU for the S12504G-AF:
1.
As shown by callouts 1 and 2 in
, remove the filler panel from the target MPU slot.
Keep the removed filler panel secure for future use.
2.
As shown by callout 3 in
, pivot up the handle of the MPU.
3.
As shown by callout 4 in
, orient the MPU with the lettering on it facing upward.
Holding the MPU by the front panel with one hand and supporting the bottom with the other,
push the MPU steadily into the slot along the guide rails.
Keep the MPU parallel to the slot to avoid touching other components in the chassis.
4.
As shown by callout 5 in
, push the MPU until the handle breaks touch the slot edges
tightly.
5.
As shown by callout 6 in
, continue to push the MPU handle until the MPU is secure in
position.
1
2
1
3
5
6
4
Summary of Contents for S12500G-AF Series
Page 32: ...3 15 Figure3 16 Connecting the grounding cable to a grounding strip 1 2 4 3 6 5 ...
Page 49: ...4 16 Figure4 16 Connecting an SFP DAC cable 1 Pull latch 2 Connector 1 2 ...
Page 92: ...A 12 FigureA 14 Example of a device label ...
Page 104: ...C 6 FigureC 5 Securing the chassis to the pallet base S12504G AF switch 1 1 2 2 1 ...
