4-5
Figure4-4 Installing a cable management bracket (S12508G-AF switch)
NOTE:
You must press the spring tab while removing a cable management bracket.
Installing fabric modules
CAUTION:
•
Before you install a fabric module on the switch, make sure the connectors on the fabric module
are not damaged or blocked.
•
When you install a fabric module, avoid damaging the connectors on it.
•
Install fabric modules or fabric module slot filler panels before you install the fan tray.
•
Install filler panels in the empty fabric module slots.
•
To replace or install a fabric module for an operating switch, first remove the fan tray that covers
the slot of the fabric module. Install the fan tray immediately after the replacement or installation.
After the fan tray starts operating, you can replace or install fabric modules whose slots are
covered by the other fan tray.
•
The smart speed adjustment feature increases the fan speed when only one fan tray is operating.
Take noise protection measures such as wearing an earmuff or earplug. In addition, make good
preparation before hot swapping a fabric module to minimize the operation time.
•
Install fabric modules from the lowest-numbered fabric module slot to the highest.
•
Do not install fabric modules of different types on the same switch.
The switch has six vertically-oriented fabric module slots at the chassis rear. The switch comes with
all fabric module slots empty. You can install two to six fabric modules for the switch. Install fabric
module slot filler panels in the empty fabric module slots.
To install a fabric module:
1.
Place the fabric module on a workbench and remove the protection box from the connector side
of the fabric module. See
Summary of Contents for S12500G-AF Series
Page 32: ...3 15 Figure3 16 Connecting the grounding cable to a grounding strip 1 2 4 3 6 5 ...
Page 49: ...4 16 Figure4 16 Connecting an SFP DAC cable 1 Pull latch 2 Connector 1 2 ...
Page 92: ...A 12 FigureA 14 Example of a device label ...
Page 104: ...C 6 FigureC 5 Securing the chassis to the pallet base S12504G AF switch 1 1 2 2 1 ...