8-7
2.
Remove the optical fibers from the transceiver module.
3.
Pull down the bail latch on the transceiver module to the horizontal position.
For a plastic pull latch, skip this step.
4.
Hold the bail latch to pull the transceiver module horizontally and slowly out of the port.
5.
Insert the dust plugs into the removed module, and put the removed module into its original
packaging materials.
6.
Install a new SFP+/SFP/SFP28/QSFP+/QSFP28/QSFP-DD transceiver module in the port. For
the installation procedure, see "Installing an SFP+/SFP/SFP28/QSFP+/QSFP28/QSFP-DD
transceiver module."
If you are not to install a new SFP+/SFP/SFP28/QSFP+/QSFP28/QSFP-DD transceiver
module in the port, install the dust plug that is provided with the module into the port, to prevent
particles from entering the port.
Replacing a network cable
CAUTION:
•
If the cable cannot be removed or installed, verify that the removal or installation procedures are
correct.
•
Pull the pull latch horizontally for smooth removal and avoiding damage.
•
If you are not to install a new network cable in the port, insert the dust plug that is provided with
the module into the port, to prevent particles from entering the port.
The replacement procedure is similar for network cables. The following procedure replaces an SFP+
DAC cable.
To replace an SFP+ DAC cable:
1.
Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded.
For more information, see "Attaching an ESD wrist strap."
2.
Gently press the cable connector in, and then pull the pull latch on the cable outward to pull out
the cable connector.
3.
Install a new SFP+ DAC cable in the port. For the installation procedure, see "Connecting a
network cable."
Summary of Contents for S12500G-AF Series
Page 32: ...3 15 Figure3 16 Connecting the grounding cable to a grounding strip 1 2 4 3 6 5 ...
Page 49: ...4 16 Figure4 16 Connecting an SFP DAC cable 1 Pull latch 2 Connector 1 2 ...
Page 92: ...A 12 FigureA 14 Example of a device label ...
Page 104: ...C 6 FigureC 5 Securing the chassis to the pallet base S12504G AF switch 1 1 2 2 1 ...