1-2
Figure1-1 Device dimensions
(1) Power supply handle
(2) Mounting bracket
(3) Cable management bracket
Attaching slide rails to the rack
To rack-mount the device, select and attach slide rails to the rack. Make sure the slide rails can
support the maximum weight of the device. See
for the maximum chassis weight and
applicable slide rails.
Table1-2 Maximum chassis weight and applicable slide rails
Max. chassis weight
(fully configured)
Applicable slide rails
Slide rail model
Adjustment range
70 kg (154.32 lb)
LSVM1BSR10
630 mm to 900 mm (24.80 in to 35.43 in)
The LSVM1BSR10 slide rails have the load-bearing flanges at its bottom and do not occupy rack
space after device installation. As a best practice, use the provided LSVM1BSR10 slide rails for the
device.
To attach slide rails to the rack:
1.
Read the signs on the slide rails to identify the front and rear ends of the slide rails.
2.
Identify the 2RU space on the rack posts for installing the slide rails.
3.
, insert the locating pins at the bottom of the slide rails into
the lowest square holes within the 2U space on the rack posts and align the four installation
holes in the slide rails with four square holes on the rack posts.
4.
As shown by callout 2 in
, mark cage nut installation holes on the rack posts. Make
sure the marked square holes are at the same height on the rack posts.
On the front rack posts, mark the bottom three square holes aligned with the installation
holes on the slide rails. The top aligned square hole will be blocked by the mounting bracket.
On the rear rack posts, mark the four square holes aligned with the installation holes on the
slide rails.
5.
As shown by callout 3 in
, install cage nuts into the marked square holes on each rack
post.
6.
As shown by callout 4 in
, use M6 screws with a recommended torque of 30 kgf-cm
(2.94 Nm) to attach the slide rails to the rack posts.
On the front rack posts, use the bottom two cage nuts for attaching the slide rails. The top cage
nut will be used for securing the mounting bracket.
7.
Ensure that the load-bearing plane of the slide rails is perpendicular to the four rack posts.
133 mm
(5.24 in)
28 mm
(1.1 in)
909 mm
(35.79 in)
104 mm
(4.09 in)
2
3
1
14 mm
(0.55 in)
