3-7
Figure 3-4 Installing a service module (S12516R)
(1) Push the service module slowly along the guide rails into the slot
(2) Pull the ejector levers outward
(3) Push the service module by the middle part on the front panel
(4) Pull the ejector levers inward
(5) Fasten the captive screws on the service module
Installing cable management brackets
The cable management brackets are installed on the two sides of the service module slots. As a best
practice, install cable management brackets after you have installed service modules.
As shown in
, insert the cable management bracket end that has a spring tab into the cable
management bracket hole until the bracket has close contact with the hole.
1
2
2
3
4
4
5
