6-2
{
For a PSR3000-54AHD power module, pressing the release latch on the power cord
connector with your forefinger of one hand (see callout 1) and squeezing the connector with
your forefinger and thumb of the other hand (see callout 2), pull out the power cord from the
power module, as shown in
Figure 6-3 Removing the power cord from a PSR3000-54AHD power module
(1) Press the release latch on the connector
(2) Pull the connector out of the power module
5.
Press the latch on the power module to the handle direction and pull the power module part way
out of the slot.
6.
Holding the power module handle with one hand and supporting the power module bottom with
another, pull the power module slowly out of the slot.
7.
Place the removed power module on the antistatic mat.
8.
Install a new power module. For information about the power module installation procedure,
see "Installing FRUs."
Figure 6-4 Removing a power module (S12516R)
(1) Press the latch to the handle direction
(2) Pull the power module slowly out of the slot along the guide rails
1
2
