28
Installing fan trays for the S12504X-AF switch
1.
Orient the fan tray correctly.
To install a fan tray in the FAN1 slot, orient the fan tray so that the LEDs are on the left side of
the front panel. To install a fan tray in the FAN2 slot, orient the fan tray so that the LEDs are on
the right side of the front panel.
2.
As shown by callout 1 in
, align the positioning pin on the fan tray with the
positioning hole in the chassis.
3.
As shown by callout 2 in
, hold the fan tray handle and insert the fan tray into the slot.
Keep the fan tray as straight and stable as possible while inserting it into the slot.
4.
As shown by callout 3 in
, fasten the captive screws on the fan tray.
Figure 26 Installing a fan tray for the S12504X-AF switch
(1) Align the positioning pin on the fan tray with the positioning hole in the chassis
(2) Insert the fan tray into the chassis
(3) Fasten the captive screws on the fan tray
Installing power modules
The power module slots are located at the two sides of the rear panel.
The installation procedure is the same for DC and AC power modules.
To install a power module:
1.
If a filler panel is installed in the slot, remove the filler panel first.
{
For a filler panel as shown in
, thread a flat-blade screwdriver through the hole in
the handle of the filler panel and pull the filler panel out.
{
For a filler panel as shown in
, use your forefinger to hold the filler panel through
the hole and pull out the filler panel along the guide rails.
2.
Correctly orient the power module.
If you install the power module in a left power module slot, make sure the latch is above the
handle. If you install the power module in a right power module slot, make sure the latch is
below the handle.
3.
Holding the handle of the power module with one hand and supporting the bottom of the power
module with the other, slide the power module along the guide rails into the slot until you hear
a click.
