Command Manual ( For Soliton ) – Management VLAN
H3C S3100 Series Ethernet Switches
Chapter 1 Management VLAN Configuration
Commands
1-9
Field
Description
Descriptions on the route state are as follows:
ActiveU
Valid unicast route. “U” stands for unicast.
Blackhole
Blackhole route is the same as reject route except that a
router drops a packet traveling along a blackhole route
without sending ICMP unreachable messages to the
source of the packets.
Delete
The route is deleted.
Gateway
The route is not a direct route.
Hidden
The route is a hidden route. The system hides routes that
are temporarily unavailable for some reasons (such as
the policy configured or the interface is down) for later
use.
Holddown
The route is held down. Holddown is a kind of route
advertisement policy used in some D-V (distance vector)
routing protocols (such as RIP) to avoid the propagation
of some incorrect routes and improve the transmission
speed of route-unreachable information. For details,
refer to corresponding routing protocols.
Int
The route is discovered by the internal gateway protocol
(IGP).
NoAdvise
The route is not advertised when the router advertises
routes based on policies
NotInstall
The route are not loaded to the core routing table but can
be advertised. Normally, the routes with the highest
preference in the routing table are loaded to the core
routing table and are advertised.
Reject
The packets travel along the route will be dropped.
Besides, the router sends ICMP unreachable messages
to the source of the dropped packets. The Reject routes
are usually used for network testing.
Retain
The route is not deleted when the routes in the core
routing table are deleted. You can enable static routes to
remain in the core routing table by configure them to be in
retain state.
Static
Static routes configured manually on the router are
marked as static. Such routes are not lost when you
perform the save operation and then restart the router.
State
Unicast
The route is a unicast route.
Age
Time period during which the route is allowed to be in the routing table,
in the form of hh:mm:ss.
Cost
Cost of the route
