Command Manual (For Soliton) – Smart Link-Monitor Link
H3C S3100 Series Ethernet Switches
Chapter 1 Smart Link Configuration
Commands
1-4
1.1.4 link-aggregation group
Syntax
link-aggregation group group-id
{
master
|
slave
}
undo link-aggregation group group-id
View
Smart Link group view
Parameter
group-id
: Link aggregation group ID, in the range of 1 to 28 (only link aggregation
groups configured manually or statically are available).
master
: Configures the specified link aggregation group as the master port of the
Smart Link group.
slave
: Configures the specified link aggregation group as the slave port of the Smart
Link group.
Description
Use the
link-aggregation group
command to configure a link aggregation group as a
member of the Smart Link group.
Use the
undo
link-aggregation group
command to remove the specified link
aggregation group from the current Smart Link group.
Note:
Because Smart Link and STP cannot be enabled on an Ethernet port at the same time,
you must make sure that STP is disabled on the port before assigning the port to a
smart link group.
Example
# Configure link aggregation group 8 as the slave port of Smart Link group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] smart-link group 1
[Sysname-smlk-group1] link-aggregation group 8 slave