Command Manual (For Soliton) – IP Address-IP Performance
H3C S3100 Series Ethernet Switches
Chapter 1 IP Address Configuration
Commands
1-4
Field
Description
Physical
Physical state of the interface
Protocol
Link layer protocol state of the interface
Description
Interface description information.
If the description has no more than 12 characters, the whole
description can be displayed. If it has more than 12
characters, only the first nine characters are displayed.
1.1.3 ip address
Syntax
ip
address
ip-address
{
mask | mask-length
}
undo ip address
[
ip-address
{
mask | mask-length
} ]
View
VLAN interface view, loopback interface view
Parameters
ip-address
: IP address, in dotted decimal notation.
mask
: Subnet mask, in dotted decimal notation.
mask-length
: Subnet mask length, the number of consecutive ones in the mask. It is in
the range of 0 to 32.
Description
Use the
ip address
command to specify an IP address and mask for a VLAN or
loopback interface.
Use the
undo ip address
command to remove an IP address and mask of a VLAN or
loopback interface.
By default, no IP address is configured for VLAN or loopback interface.
Note:
z
A newly specified IP address overwrites the previous one if there is any.
z
The IP address of a VLAN interface must not be in the same network segment as
that of a loopback interface on a device.
Related commands:
display ip interface
.