Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
Chapter 1 Port Basic Configuration
Commands
1-1
Chapter 1 Port Basic Configuration Commands
Note:
A new parameter
kbps
is added in the command
storm-constrain
in the software
version Release 2301.
1.1 Port Basic Configuration Commands
1.1.1 broadcast-suppression
Syntax
broadcast-suppression
{
ratio | bps max-bps
}
undo
broadcast-suppression
View
System view, Ethernet port view
Parameter
ratio
: Maximum ratio of the broadcast traffic allowed on a port to the total transmission
capacity of the port. The value ranges from 1 to 100 (in step of 1) and defaults to 100.
The smaller the ratio is, the less broadcast traffic is allowed.
max
-
bps
: Maximum number (in Kbps) of broadcast traffic that can be received per
second on an Ethernet port (in step of 64). This argument can only be configured on
Ethernet port view.
z
For a 100Mbps Ethernet port, the
max-bps
argument is in the range 64 to 99,968.
z
For a GigabitEthernet port, the
max-bps
argument is in the range 64 to 1,000,000.
Description
Use the
broadcast-suppression
command to limit broadcast traffic allowed to be
received on each port (in system view) or on a specified port (in Ethernet port view).
Use the
undo broadcast-suppression
command to restore the default broadcast
suppression setting.
The
broadcast-suppression
command is used to enable broadcast suppression. By
default, broadcast suppression is disabled.
