Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
Chapter 1 Port Basic Configuration
Commands
1-9
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 1-3
Description on the fields of the
display interface
command
Field
Description
Ethernet1/0/1 current state
Current status of the Ethernet port : UP,
DOWN or ADMINISTRATIVELY DOWN
IP Sending Frames' Format
Ethernet frame format
Hardware address
Port hardware address
Media type
Media type
Port hardware type
Port hardware type
100Mbps-speed mode, full-duplex mode
Current speed mode and duplex mode
Link speed type is force link, link duplex
type is force link
Link speed and duplex status ( force or
auto-negotiation)
Flow-control is enabled
Status of flow-control on the port
The Maximum Frame Length
Maximum frame length allowed on the
port
Broadcast MAX-bps
Broadcast suppression ratio on the port
Multicast MAX-bps
Multicast suppression ratio on the port
Allow jumbo frame to pass
Whether Jumbo frame is allowed on the
port.
PVID
Default VLAN ID of the port
Mdi type
Network cable type
Port link-type
Port link type
Tagged VLAN ID
Identify the VLANs whose packets will
be forwarded with tags on the port.
Untagged VLAN ID
Identify the VLANs whose packets will
be forwarded without tags on the port.
Last 300 seconds input: 0 packets/sec 0
bytes/sec
Last 300 seconds output: 0 packets/sec
0 bytes/sec
Rate and number of incoming and
outgoing packets in the last 300 seconds
