Command Manual (For Soliton) – Port Isolation
H3C S3100 Series Ethernet Switches
Chapter 1 Port Isolation Configuration
Commands
1-2
Description
Use the
port isolate
command to add an Ethernet port to the isolation group.
Use the
undo port isolate
command to remove an Ethernet port from the isolation
group.
Note:
z
When a member port of an aggregation group joins/leaves an isolation group, the
other ports in the same aggregation group on the local device will join/leave the
isolation group at the same time.
z
For ports that belong to an aggregation group and an isolation group simultaneously,
removing a port from the aggregation group has no effect on the other ports. That is,
the rest ports remain in the aggregation group and the isolation group.
z
Ports that belong to an aggregation group and an isolation group simultaneously are
still isolated even when you remove the aggregation group in system view.
z
Adding a port of an isolation group to an aggregation group causes all the ports in
the aggregation group being added to the isolation group.
By default, the isolation group contains no port.
Example
# Add Ethernet1/0/1 to the isolation group.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet1/0/1
[Sysname-Ethernet1/0/1] port isolate
# Remove Ethernet1/0/1 from the isolation group.
[Sysname-Ethernet1/0/1] undo port isolate
