Command Manual ( For Soliton ) – Port Security-Port Binding
H3C S3100 Series Ethernet Switches
Chapter 1 Port Security Commands
1-10
Dot1x logon trap is Enabled
Dot1x logoff trap is Enabled
Dot1x logfailure trap is Enabled
RALM logon trap is Enabled
RALM logoff trap is Enabled
RALM logfailure trap is Enabled
Disableport Timeout: 20 s
OUI value:
Index is 5, OUI value is 000100
Blocked Mac info:
MAC ADDR From Port Vlan
--- On unit 1, 2 blocked mac address(es) found. ---
0000-0000-0003 Ethernet1/0/1 1
0000-0000-0004 Ethernet1/0/1 1
--- 2 blocked mac address(es) found. ---
Ethernet1/0/1 is link-up
Port mode is Secure
NeedtoKnow mode is disabled
Intrusion mode is BlockMacaddress
Max mac-address num is 2
Stored mac-address num is 2
Authorization is permit
For description on the output information, refer to
Table 1-2
.
# Configure the intrusion protection mode on Ethernet 1/0/1 as
disableport-temporarily
. As a result, the port will be disconnected when intrusion
protection is triggered and then re-enabled 30 seconds later.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] port-security timer disableport 30
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] port-security intrusion-mode
disableport-temporarily
# Configure the intrusion protection mode on Ethernet 1/0/1 as
disableport
. As a result,
when intrusion protection is triggered, the port will be disconnected permanently.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] port-security intrusion-mode disableport