Command Manual (For Soliton) – Login
H3C S3100 Series Ethernet Switches
Chapter 1 Login Commands
1-11
Examples
# Release user interface VTY 1.
<Sysname> free user-interface vty 1
Are you sure you want to free user-interface vty1 [Y/N]? y
[OK]
After you perform the above operation, the user connection on user interface VTY1 is
torn down. The user in it must log in again to connect to the switch.
1.1.9 header
Syntax
header
[
incoming
|
legal
|
login
|
shell
]
text
undo header
{
incoming
|
legal
|
login
|
shell
}
View
System view
Parameters
incoming
: Sets the login banner for users that log in through modems. If you specify to
authenticate login users, the banner appears after a user passes the authentication.
(The session does not appear in this case.)
legal
: Sets the authorization banner, which is displayed when a user enters user view.
login
: Sets the login banner. The banner set by this keyword is valid only when users
are authenticated before they log in to the switch and appears while the switch prompts
for user name and password. If a user logs in to the switch through Web, the banner
text configured will be displayed on the banner page.
shell
: Sets the session banner, which appears after a session is established. If you
specify to authenticate login users, the banner appears after a user passes the
authentication.
text
: Banner to be displayed. If no keyword is specified, this argument is the login
banner. You can provide this argument in two ways. One is to enter the banner in the
same line as the command (A command line can accept up to 254 characters.) The
other is to enter the banner in multiple lines (you can start a new line by pressing Enter,)
where you can enter a banner that can contain up to 2000 characters (including the
invisible characters such as carriage return). Note that the first character is the
beginning character and the end character of the banner. After entering the end
character, you can press Enter to exit the interaction.