Command Manual (For Soliton) – MSTP
H3C S3100 Series Ethernet Switches
Chapter 1 MSTP Configuration Commands
1-7
TCN: 0, Config: 0, RST: 0, MST: 0
BPDU Received :0
TCN: 0, Config: 0, RST: 0, MST: 0
Table 1-3 display stp
command output description
Field
Description
CIST Bridge
CIST bridge ID
Bridge Times
Major parameters for the bridge:
z
Hello: Hello timer
z
MaxAge: Max Age timer
z
FwDly: Forward delay timer
z
MaxHop: Max hops within the MST region
CIST Root/ERPC
CIST root and external path cost
CIST RegRoot/IRPC
CIST regional root and internal path cost
CIST RootPortId
CIST root port ID
BPDU-Protection
Indicates whether BPDU protection is enabled
globally.
TC-Protection*** /
Threshold=**
Indicates whether TC-BPDU attack guard function is
enabled globally, and the maximum times that a
switch can remove the MAC address table and ARP
entries within each 10 seconds.
Bridge Config
Digest Snooping
Indicates whether Digest Snooping is enabled
globally on the bridge.
TC or TCN received
Number of received TC/TCN packets
Time since last TC
Time of the latest topology change
Port Protocol
Indicates whether STP is enabled on the port
Port Role
Port role, which can be Alternate, Backup, Root,
Designated, Master, or Disabled
Port Priority
Port priority
Port Cost(Legacy)
Path cost of the port. The field in the bracket indicates
the standard used for port path cost calculation, which
can be
legacy
,
dot1d-1998
, or
dot1t
.
Config
indicates the configured value, and
Active
indicates
the actual value.
Desg. Bridge/Port
Designated bridge ID and port ID of the port
The port ID displayed is insignificant for a port which
does not support port priority.
Port Edged
Indicates whether the port is an edge port.
Config
indicates the configured value, and
Active
indicates
the actual value.