Command Manual (For Soliton) – MSTP
H3C S3100 Series Ethernet Switches
Chapter 1 MSTP Configuration Commands
1-15
System View: return to User View with Ctrl+Z.
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
1.1.13 stp
Syntax
stp
{
enable
|
disable
}
undo stp
View
System view, Ethernet port view
Parameters
enable
: Enables MSTP globally or on a port.
disable
: Disables MSTP globally or on a port.
Description
Use the
stp
command to enable/disable MSTP globally or on a port.
Use the
undo stp
command to restore the MSTP state to the default globally or on a
port.
By default, MSTP is disabled.
After MSTP is enabled, the actual operating mode, which can be STP-compatible mode,
RSTP-compatible mode, or MSTP mode, is determined by the user-defined protocol
mode. A switch becomes a transparent bridge if MSTP is disabled.
After being enabled, MSTP maintains spanning trees by processing configuration
BPDUs of different VLANs. After being disabled, it stops maintaining spanning trees.
Related commands:
stp mode
,
stp interface
.
Examples
# Enable MSTP globally.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] stp enable
# Disable MSTP on Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp disable