Command Manual (For Soliton) – 802.1x-System Guard
H3C S3100 Series Ethernet Switches
Chapter 1 802.1x Configuration Commands
1-6
Note:
z
Configurations of 8021.x and the maximum number of MAX addresses that can be
learnt are mutually exclusive. That is, when 802.1x is enabled for a port, it cannot
also have the maximum number of MAX addresses to be learned configured at the
same time. Conversely, if you configure the maximum number of MAX addresses
that can be learnt for a port, 802.1x is unavailable to it.
z
If you enable 802.1x for a port, it is not available to add the port to an aggregation
group. Meanwhile, if a port has been added to an aggregation group, it is prohibited
to enable 802.1x for the port.
Related command:
display dot1x
.
Example
# Enable 802.1x for Ethernet1/0/1 port.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dot1x interface Ethernet 1/0/1
# Enable 802.1x globally.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dot1x
1.1.3 dot1x authentication-method
Syntax
dot1x authentication-method
{
chap | pap | eap
}
undo dot1x authentication-method
View
System view
Parameter
chap
: Authenticates using challenge handshake authentication protocol (CHAP).
pap
: Authenticates using password authentication protocol (PAP).
eap
: Authenticates using extensible authentication protocol (EAP).
Description
Use the
dot1x authentication-method
command to set the 802.1x authentication
method.