Command Manual (For Soliton) – 802.1x-System Guard
H3C S3100 Series Ethernet Switches
Chapter 4 System-Guard Configuration
Commands
4-5
system-guard function is to be applied to. A switch checks the ports with the
system-guard function applied regularly for attacked ports.
Use the
undo system-guard permit
command to disable the system-guard function
for specified ports.
By default, the system-guard function is disabled on a port.
Example
# Apply the system-guard function to Ethernet1/0/1 through Ethernet1/0/10 ports.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] system-guard permit Ethernet 1/0/1 to Ethernet 1/0/10
4.1.6 system-guard timer-interval
Syntax
system-guard timer-interval isolate-timer
undo system-guard timer-interval
View
System view
Parameter
isolate-timer
: Length of the isolation after an attack is detected, in the range of 1 to
10,000 in minutes.
Description
Use the
system-guard timer-interval
command to set the length of the isolation after
an attack is detected.
Use the
undo system-guard timer-interval
command to restore the length of the
isolation to the default value.
By default, the length of the isolation after an attack is detected is 10 minutes.
Related command:
display system-guard state
.
Example
# Set the length of the isolation after an attack is detected to 20 minutes.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname]system-guard timer-interval 20
