Command Manual (For Soliton) – AAA
H3C S3100 Series Ethernet Switches
Chapter 1 AAA Configuration Commands
1-69
undo hwtacacs nas-ip
View
System view
Parameters
ip-address
: Source IP address to be set, an IP address of this device. This address can
neither be the all 0's address nor be a Class D address.
Description
Use the
hwtacacs nas-ip
command to set the source address of outgoing
HWTACACS messages.
Use the
undo hwtacacs nas-ip
command to restore the default setting.
By default, no source address is specified, and the IP address of corresponding
outbound interface is used as the source address.
Note that:
z
You can specify the source address of outgoing HWTACACS messages to avoid
messages returned from server from being unable to reach their destination due to
physical interface trouble. It is recommended to use a Loopback interface address
as the source IP address.
z
You can specify only one source IP address by using this command. When you
re-execute this command again, the newly set source IP address will overwrite the
old one.
Related commands:
nas-ip
.
Examples
# Configure the switch to use source address 129.10.10.1 for outgoing HWTACACS
messages.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs nas-ip 129.10.10.1
1.3.5 hwtacacs scheme
Syntax
hwtacacs scheme
hwtacacs-scheme-name
undo hwtacacs scheme
hwtacacs-scheme-name
View
System view