Command Manual (For Soliton) – AAA
H3C S3100 Series Ethernet Switches
Chapter 1 AAA Configuration Commands
1-74
undo primary authorization
View
HWTACACS scheme view
Parameters
ip-address
: IP address of the primary authorization server to be used, a valid unicast
address in dotted decimal notation.
port
: Port number of the primary authorization server, ranging from 1 to 65535.
Description
Use the
primary authorization
command to set the IP address and port number of the
primary HWTACACS authorization server to be used by the current scheme.
Use the
undo primary authorization
command to restore the default IP address and
port number of the primary authorization server, which are 0.0.0.0 and 49 respectively.
Note that:
z
You are not allowed to set the same IP address for both primary and secondary
authorization servers. If you do this, your setting will fail.
z
If you re-execute the command, the new setting will overwrite the old one.
z
You can remove an authorization server setting only when there is no active TCP
connection that is sending authorization messages to the server.
Related commands:
display hwtacacs
.
Examples
# Set the IP address and UDP port number of the primary authorization server for
HWTACACS scheme hwt1 to 10.163.155.13 and 49 respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49
1.3.11 reset hwtacacs statistics
Syntax
reset hwtacacs statistics
{
accounting
|
authentication
|
authorization
|
all
}
View
User view
Parameters
accounting
: Clears HWTACACS accounting statistics.