Command Manual (For Soliton) – ACL
H3C S3100 Series Ethernet Switches
Chapter 1 ACL Configuration Commands
1-20
Name
ICMP type
ICMP code
net-unreachable
Type=3 Code=0
parameter-problem
Type=12 Code=0
port-unreachable
Type=3 Code=3
protocol-unreachable
Type=3 Code=2
reassembly-timeout
Type=11 Code=1
source-quench
Type=4 Code=0
source-route-failed
Type=3 Code=5
timestamp-reply
Type=14 Code=0
timestamp-request
Type=13 Code=0
ttl-exceeded
Type=11 Code=0
II. Parameters of the undo rule command
rule-id
: Rule ID, which must the ID of an existing ACL rule. You can obtain the ID of an
ACL rule by using the
display acl
command.
source
: Removes the settings concerning the source address in the ACL rule.
source-port
: Removes the settings concerning the source port in the ACL rule. This
keyword is only available to the ACL rules with their protocol types set to TCP or UDP.
destination
: Removes the settings concerning the destination address in the ACL rule.
destination-port
: Removes the settings concerning the destination port in the ACL rule.
This keyword is only available to the ACL rules with their protocol types set to TCP or
UDP.
icmp-type
: Removes the settings concerning the ICMP type and message code in the
ACL rule. This keyword is only available to the ACL rules with their protocol type set to
ICMP.
precedence
: Removes the precedence-related settings in the ACL rule.
tos
: Removes the ToS-related settings in the ACL rule.
dscp
: Removes the DSCP-related settings in the ACL rule.
ttl
: Removes the TTL-related settings in the ACL rule.
time-range
: Removes the time range settings in the ACL rule.
fragment
: Removes the settings concerning non-tail fragments in the ACL rule.