Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 1 Stack Function Configuration
Commands
1-3
1.1.2 stack-port enable
Syntax
stack-port enable
undo stack-port enable
View
Ethernet port view
Parameters
None
Description
Use the
stack-port enable
command to allow the stack port to send/forward stack
join-in requests to/from its connected switch.
Use the
undo
stack-port enable
command to prohibit the stack port from
sending/forwarding stack join-in requests to/from its connected switch.
By default, the stack-port function on a stack port is enabled, indicating that a switch
can send/forward the stack join-in requests through the port.
Examples
# Enable the stack-port function on a stack port.
<stack_1.Sysname> system-view
System View: return to User View with Ctrl+Z.
[stack_1.Sysname] interface GigabitEthernet 1/1/2
[stack_1.Sysname-GigabitEthernet1/1/2] stack-port enable
1.1.3 stacking
Syntax
stacking number
View
User view
Parameter
number
: Number of the slave switch to switch.
Description
Use the
stacking
command to switch to a slave switch to configure it.