Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-1
Chapter 2 HGMP V2 Configuration Commands
2.1 NDP Configuration Commands
2.1.1 display ndp
Syntax
display ndp
[
interface
interface-list
]
View
Any view
Parameters
interface interface-list
: Specifies a port list. You need to provide the
interface-list
argument in the form of {
interface-type interface-number
[
to
i
nterface-type
interface-number
] } &<1-10>, where
to
is used to specify a port range, and &<1-10>
means that you can provide up to ten port indexes/port index ranges for this argument.
The
interface-number
argument is in the format of unit ID/slot number/port number.
Description
Use the
display ndp
command to display all NDP configuration and operating
information, including the global NDP status, the interval to send NDP packets, the
holdtime of NDP information, and the NDP status and neighbor information on all ports.
If executed with the
interface
keyword, the
display ndp
command will display the NDP
status of the specified interfaces and the related information of the peer device. If
executed without the
interface
keyword, the command will display the global NDP
configuration information and the statistics on NDP packets received on and sent by
each port.
Examples
# Display all NDP configuration and operating information.
<aaa_0.Sysname> display ndp
Neighbor Discovery Protocol is enabled.
Neighbor Discovery Protocol Ver: 1, Hello Timer: 60(s), Aging Timer: 180(s)
Interface: Ethernet1/0/1
Status: Enabled, Pkts Snd: 15835, Pkts Rvd: 2879, Pkts Err: 0