Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-3
Field
Description
Neighbor 1: Aging Time
Holdtime for this switch to keep the NDP
information of the neighbor connected to
the port
MAC Address
MAC address of the neighbor device
Host Name
Host name of the neighbor device
Port name
Port name of the neighbor device
Software Ver
Software version of the neighbor device
Device Name
Device name of the neighbor device
Port Duplex
Port (full/half) duplex mode of the
neighbor device
Product Ver
Product version of the neighbor device
BootROM Ver
Bootrom version of the neighbor device
2.1.2 ndp enable
Syntax
ndp enable
[
interface interface-list
]
undo ndp enable
[
interface interface-list
]
View
System view, Ethernet port view
Parameters
interface-list
: Ethernet port list, in the format of {
interface-type interface-number
[
to
i
nterface-type interface-number
] } &<1-10>, where
to
is used to specify a port range,
and &<1-10> means that you can provide up to ten port indexes/port index ranges for
this argument. The
interface-number
argument is in the format of unit ID/slot
number/port number.
Description
Use the
ndp enable
command to enable NDP globally or on a port.
Use the
undo ndp enable
command to disable NDP globally or on a port.
If you execute the
ndp enable
command in system view without the
interface
keyword
specified, NDP will be enabled globally; if you specify the
interface
keyword in the
command, NDP will be enabled on the specified ports. In Ethernet port view, the
interface
keyword is unavailable, and execution of the command will enable NDP on
the current port only.
