Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-20
Parameters
name
: Name to be set for the cluster, a string of up to 8 characters, which can only be
alphanumeric characters, minus signs (-), and underscores (_).
Description
Use the
build
command to build a cluster with a cluster name or change the cluster
name.
Use the
undo build
command to remove the cluster.
You can use this command on a candidate device as well as on a management device.
Executing the
build
command on a candidate device will change the device to a
management device and assign a name to the cluster created on the device, and the
member number of the management device is 0.
Executing the
build
command on a management device will change the cluster name.
Different from the
auto-build
command, the
build
command only builds a cluster on
the management device, which will not immediately collect the topology information to
add the candidate devices into the cluster, but wait for an interval (configured through
the
ntdp timer
command) before it starts the topology collection.
