Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-23
Use the
undo cluster enable
command to disable the cluster function.
By default, the cluster function is enabled.
Note that:
z
To create a cluster on a management device through the
build
command or the
auto-build
command, you must first enable the cluster function by executing the
cluster enable
command.
z
When you execute the
undo cluster enable
command on the management
device, the cluster function is disabled on the device, and the device stops
operating as a management device, and the cluster and all its members are
removed.
z
When you execute the
undo cluster enable
command on a member device, the
cluster function is disabled on the device, and the device leaves the cluster.
z
When you execute
undo cluster enable
command on a device that does not
belong to any cluster, the cluster function is disabled on the device, and thus you
cannot create a cluster on the device or add the device to an existing cluster.
Examples
# Enable the cluster function on the switch.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] cluster enable
2.3.7 cluster switch-to
Syntax
cluster switch-to
{
member-number
|
mac-address
H-H-H
|
administrator
}
View
User view
Parameters
member-number
: Member number of a member device, ranging from 1 to 255.
mac-address
H-H-H
: Specifies the MAC address of a member device.
administrator
: Switches back from the member device to the management device.
Description
Use the
cluster switch-to
command to switch between the management device and a
member device for configuration and management.
On the management device, you can switch to the view of a member device to
configure and manage the member device, and then switch back to the management
device.
