Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-28
Description
Use the
display cluster
command to display the status and statistics information of the
cluster to which the current switch belongs.
Executing this command on a member device will display the following information:
cluster name, member number of the current switch, MAC address and status of the
management device, holdtime, and interval to send handshake packets.
Executing this command on a management device will display the following information:
cluster name, number of the member devices in the cluster, cluster status, holdtime,
and interval to send handshake packets.
Executing this command on a device that does not belong to any cluster will display an
error.
Examples
# Display cluster information on a management device.
<aaa_0.Sysname-cluster> display cluster
Cluster name:"aaa"
Role:Administrator
Management-vlan:100
Handshake timer:10 sec
Handshake hold-time:60 sec
IP-Pool:20.1.1.1/24
cluster-mac:0180-c200-000a
No logging host configured
No SNMP host configured
No FTP server configured
No TFTP server configured
3 member(s) in the cluster, and 0 of them down.
# Display cluster information on a member device.
[aaa_2.3100-3] display cluster
Cluster name:"aaa"
Role:Member
Member number:2
Management-vlan:100
cluster-mac:0180-c200-000a
Handshake timer:10 sec
Handshake hold-time:60 sec
