Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-38
2.3.19 management-vlan
Syntax
management
-
vlan
vlan-id
undo management
-
vlan
View
System view
Parameters
vlan-id
: ID of the VLAN to be specified as the management VLAN.
Description
Use the
management
-
vlan
command to specify the management VLAN on the switch.
Use the
undo management
-
vlan
command to restore the default management VLAN.
By default, VLAN 1 is used as the management VLAN.
When specifying the management VLAN, note that:
z
The management VLANs on all the devices in a cluster must be the same.
z
You can specify the management VLAN on a device only when no cluster is
created on the device. You cannot change the management VLAN on a device
that already joins a cluster. If you want to change the management VLAN on a
device where a cluster has already been created, you must first remove the cluster
configuration on the device, then re-specify a VLAN as the management VLAN,
and finally re-created the cluster.
z
The management VLAN of a cluster defaults to VLAN 1. To isolate cluster
management packets from other packets to improve the cluster information
security, it is recommended to configure the management VLAN of the cluster as
another VLAN.
Examples
# Specify VLAN 2 as the management VLAN of the current switch.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] management-vlan 2
2.3.20 reboot member
Syntax
reboot member
{
member-number
|
mac-address H-H-H
}
[
eraseflash
]