Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-47
Table 2-10
Description on the fields of
display cluster base-members
Field
Description
SN
Device number in the cluster
Device Device
name
MAC Address
Device MAC address
Status
Device status
Up: The member is connected.
Down: The member is disconnected.
2.4.3 display cluster base-topology
Syntax
display cluster base-topology
[
mac-address mac-address
|
member member-id
]
View
Any view
Parameters
mac-address mac-address
: Displays the structure of the standard topology three
layers above or below the node specified by the MAC address.
member member-id
: Displays the structure of the standard topology three layers above
or below the node specified by the member ID.
Description
Use the
display cluster base-topology
command to display the standard topology of
the cluster.
The standard topology of a cluster refers to the topology saved through the
topology
save-to
command. The standard topology is the backup of the normal topology
information of a cluster and is mainly used to resume the normal topology of the cluster
member devices in case the cluster topology encounters a fault.
Examples
# Display the standard topology of the cluster.
<aaa_0.Sysname> display cluster base-topology
--------------------------------------------------------------------
(PeerPort) ConnectFlag (NativePort) [SysName:DeviceMac]
--------------------------------------------------------------------
[aaa_0.Sysname:000f-e202-2180]
|