Command Manual (For Soliton) – VLAN
H3C S3100 Series Ethernet Switches
Chapter 1 VLAN Configuration Commands
1-2
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] description gateway of LAB1
1.1.2 display interface Vlan-interface
Syntax
display
interface Vlan-interface
[
vlan-id
]
View
Any view
Parameters
vlan
-
id
: Specifies a VLAN interface number.
Description
Use the
display
interface Vlan-interface
command to display information about the
specified VLAN interface or all VLAN interfaces already created if no VLAN interface is
specified.
The output of this command shows the state, IP address, description and other
information of a VLAN interface. You can use the information to troubleshoot network
problems.
Related commands:
interface Vlan-interface
.
Examples
# Display information about VLAN-interface 1.
<Sysname> display interface Vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
000f-e20f-4101
Internet Address is 10.1.1.1/24 Primary
Description : Vlan-interface1 Interface
The Maximum Transmit Unit is 1500