Command Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Chapter 3 Device Management
Commands
3-7
<Sysname> display schedule reboot
System will reboot at 16:00:00 2002/11/1 (in 2 hours and 5 minutes).
3.1.9 display transceiver alarm interface
Syntax
display transceiver alarm interface
[
interface-type
interface-number
]
View
Any view
Parameters
interface-type interface-number:
Interface type and interface number.
Description
Use the
display transceiver alarm interface
command to display the current alarm
information of a single or all transceivers.
If no error occurs,
None
is displayed.
Table 3-5
shows the alarm information that may occur for the four types of transceivers.
Table 3-5
Description on the fields of display transceiver alarm interface
Field
Remarks
GBIC/SFP
RX loss of signal
RX signal is lost.
RX power high
RX power is high.
RX power low
RX power is low.
TX fault
TX fault
TX bias high
TX bias current is high.
TX bias low
TX bias current is low.
TX power high
TX power is high.
TX power low
TX power is low.
Temp high
Temperature is high.
Temp low
Temperature is low.
Voltage high
Voltage is high.
Voltage low
Voltage is low.
Transceiver info I/O error
Transceiver information read and write error
Transceiver info checksum error
Transceiver information checksum error
