Command Manual (For Soliton) – IPv6 Management
H3C S3100 Series Ethernet Switches
Chapter 1 IPv6 Configuration Commands
1-9
Field
Description
State
State of a neighbor, which can be:
z
INCMP: Address resolution is in progress, so the link
layer address of the neighbor is unknown yet.
z
REACH: The neighbor is reachable.
z
STALE: The reachability to the neighbor is unknown. The
device does not verify the reachability to the neighbor
unless it sends a packet to the neighbor.
z
DELAY: The reachability to the neighbor is unknown. The
device will send a neighbor request message after a
delay time.
z
PROBE: The reachability to the neighbor is unknown.
The device sent a neighbor request message to verify the
reachability.
T
Type of neighbor information, including S (static
configuration) and D (dynamic acquisition).
Age
z
For a static entry, “-“ is displayed.
z
For a dynamic entry, the time (in seconds) since it is
reachable last time is displayed, and if it is never
reachable, “#” is displayed (for a dynamic neighbor only).
1.1.6 display ipv6 neighbors count
Syntax
display ipv6 neighbors
{
all | dynamic
|
static
|
interface interface-type
interface-number
|
vlan
vlan-id
}
count
View
Any view
Parameters
all
: Displays the total number of all neighbor entries, including neighbor entries
acquired dynamically and configured statically.
dynamic
: Displays the total number of all neighbor entries acquired dynamically.
static
: Displays the total number of all neighbor entries configured statically.
interface interface-type interface-number
: Displays the total number of neighbor
entries of a specified interface.
vlan
vlan-id
: Displays the total number of neighbor entries of a specified VLAN, in the
range of 1 to 4,094.
count
: Number of neighbor entries.