122
Before collecting the traffic statistics within a specific period of time on an interface, you need to clear the
existing statistics first.
•
If the
vlan-interface-id
argument is not specified, this command clears the statistics of all VLAN
interfaces.
•
If the
vlan-interface-id
argument is specified, this command clears the statistics of the specified
VLAN interface.
Related commands:
display interface vlan-interface
.
Examples
# Clear the statistics on VLAN-interface 2.
<Sysname> reset counters interface vlan-interface 2
shutdown
Syntax
shutdown
undo shutdown
View
VLAN interface view
Default level
2: System level
Parameters
None
Description
Use the
shutdown
command to shut down a VLAN interface.
Use the
undo shutdown
command to bring up a VLAN interface.
By default, a VLAN interface is up except when all ports in the VLAN are down.
You can use the
undo shutdown
command to bring up a VLAN interface after configuring related
parameters and protocols for the VLAN interface. When a VLAN interface fails, you can shut down the
interface with the
shutdown
command and then bring it up with the
undo shutdown
command. In this
way, the interface may resume.
The state of any Ethernet port in a VLAN is independent of the VLAN interface state.
Examples
# Shut down VLAN-interface 2 and then bring it up.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] shutdown
[Sysname-Vlan-interface2] undo shutdown
vlan
Syntax
vlan
{
vlan-id1
[
to
vlan-id2
] |
all
}
