143
Configuring GigabitEthernet1/0/2... Done.
Configuring GigabitEthernet1/0/3........................................... Done.
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring GigabitEthernet1/0/2... Done.
Configuring GigabitEthernet1/0/3... Done.
[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0
protocol-vlan
Syntax
protocol-vlan
[
protocol-index
] {
at
|
ipv4 | ipv6
|
ipx
{
ethernetii
|
llc
|
raw
|
snap
} |
mode
{
ethernetii
etype
etype-id
|
llc
{
dsap
dsap-id
[
ssap
ssap-id
]
|
ssap
ssap-id
} |
snap
etype
etype-id
} }
undo protocol-vlan
{
protocol-index
[
to
protocol-end
] |
all
}
View
VLAN view
Default level
2: System level
Parameters
at
: Specifies the AppleTalk based VLAN.
ipv4
: Specifies the IPv4 based VLAN.
ipv6
: Specifies the IPv6 based VLAN.
ipx
: Specifies the IPX based VLAN. The keywords
ethernetii
,
llc
,
raw
, and
snap
are encapsulation
formats for IPX.
mode
: Configures a user-defined protocol template for the VLAN, which could also have the following
encapsulation formats:
ethernetii
,
llc
,
raw
, and
snap
.
ethernetii etype
etype-id
: Specifies to match Ethernet II encapsulation format and the corresponding
protocol type values. The
etype-id
argument is the protocol type ID of inbound packets, ranging from
0x0600 to 0xffff (excluding 0x0800, 0x809b, 0x8137, and 0x86dd).
llc
: Specifies to match the
llc
encapsulation format.
dsap
dsap-id
: Specifies the destination service access point, ranging from 00 to 0xff.
ssap
ssap-id
: Specifies the source service access point, ranging from 00 to 0xff.
snap etype
etype-id
: Specifies to match SNAP encapsulation format and the corresponding protocol type
values. The
etype-id
argument is the Ethernet type of inbound packets, ranging from 0x0600 to 0xffff
(excluding
ipx snap
under the
snap
encapsulation format).
protocol-index
: Specifies a protocol template index. System will automatically assign an index if this
parameter is not specified. The
protocol-end
argument is in the range of 0 to 7.
to
protocol-end
: Specifies the end protocol index. The
protocol-end
argument must be greater than or
equal to the
protocol-index
argument
.
The
protocol-end
argument is in the range of 0 to 7.
all
: Specifies to remove all the protocols bound to the current VLAN.