48
vlan
vlan
-
id
: Specifies an existing VLAN to which the Ethernet interface belongs, where
vlan-id
is the
specified VLAN ID, ranging from 1 to 4094.
Description
Use the
mac-address
command to add or modify a MAC address entry on a specified interface.
Use the
undo mac-address
command to remove a MAC address entry on the interface.
The MAC address entries configuration cannot survive a reboot unless you save it. The dynamic MAC
address table entries will be lost, whether you save the configuration or not.
Related commands:
display mac-address
.
Examples
# Add a static entry for MAC address 000f-e201-0101 on port Ethernet 1/1 that belongs to VLAN 2.
<Sysname> system-view
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] mac-address static 000f-e201-0101 vlan 2
# Add a static entry for MAC address 000f-e201-0102 on port Bridge-Aggregation 1 that belongs to
VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-Aggregation 1
[Sysname-Bridge-Aggregation1] mac-address static 000f-e201-0102 vlan 1
mac-address (system view)
Syntax
mac-address blackhole
mac
-
address
vlan
vlan
-
id
mac-address
{
dynamic
|
static
}
mac
-
address
interface
interface
-
type interface
-
number
vlan
vlan
-
id
undo mac-address
[ {
dynamic
|
static
}
mac
-
address
interface
interface
-
type interface
-
number
vlan
vlan
-
id
]
undo mac-address
[
blackhole
|
dynamic
|
static
]
[
mac
-
address
]
vlan
vlan
-
id
undo mac-address
[
dynamic
|
static
]
mac-address
interface
interface
-
type interface
-
number
vlan
vlan
-
id
undo mac-address
[
dynamic
|
static
]
interface
interface
-
type interface
-
number
View
System view
Default level
2: System level
Parameters
blackhole
: Specifies destination blackhole MAC address entries. These entries do not age, but you can
add or remove them. The packets whose destination MAC addresses match destination blackhole MAC
address entries are dropped.
mac
-
address
: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted. For example, inputting “f-e2-1” indicates that the MAC
address is “000f-00e2-0001”.
